60
61
6.8 Adjusting the side panels
Side panel with protection against cold, side panel with splash guard and protection against cold, carbon
side panel with splash guard
The side panels have to be fine-tuned when the drive wheel position is changed.
1) Remove the drive wheel.
2) Loosen the mounting screws on the side panel (see fig. 62, item 1).
3) Attach the drive wheel to determine the position.
4) Adjust the position of the side panel (see fig. 62, item 2). Adjust the height so the top edge is about
25 mm
higher than the wheel surface to prevent pinching the fingers.
INFORMATION: Align the side panels downward.
5) Tighten the mounting screws.
6) Attach the drive wheel and check the freewheel.
→
After adjustment, the side panels have to be aligned the same on both sides.
62
“Plastic, plug-on” side panel
The height of the forearm support can be best adjusted when the side panel is completely removed.
1)
Height adjustment of the forearm support:
Use a ballpoint pen or screwdriver to press the countersunk
locking button (see fig. 63, item 1). Move the forearm support to the desired position so the locking button re-
engages. Then fully insert the side panel back into the retainer on the wheelchair.
CAUTION! The locking button is intentionally countersunk to prevent accidental operation. Always use
an object to press the locking button, never your fingers.
2)
Depth adjustment of the forearm support:
Loosen the mounting screws under the forearm support, move
the forearm support and re-tighten the mounting screws (see fig. 64, item 1).
27
Motus CV, Motus CS
Settings
