7
8
9
10
6.2.4 Adjusting the track
INFORMATION
►
The track setting must be checked and, if necessary, adjusted after the following adjustments have been
made:
→
Adjusting the vertical position of the drive wheels
→
Adjusting the horizontal position of the drive wheels
►
The track setting must be adjusted after the following adjustments have been made:
→
Adjusting the drive wheel camber
→
Adjusting the track
INFORMATION
►
Always adjust the track on both sides and check both sides.
►
With each track adjustment, always check the symmetry of the track width setting.
►
The caster wheel journal angle should be checked immediately after every adjustment to the track (see
page 14).
1) Slightly loosen the hexagon nuts (see fig. 11, item 1) on the quick-release axle mounting.
2) Use the adjustment aid (spirit level) (see fig. 11, item 2) to adjust the track by turning the hexagon nut slightly.
3) Tighten the hexagon nuts on both sides of the quick-release axle mounting to
40 Nm
.
→
Once adjusted, the left and right quick-release axle mountings must both be in the same vertical position in the
frame.
12
Settings
Motus CV, Motus CS
