CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
►
Always firmly re-tighten the mounting screws and nuts after changing settings. Observe the specified torques
in doing so.
►
Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite 241).
►
Always replace self-locking screws and nuts with new self-locking screws and nuts after disassembly.
Fine-tuning and adjustments should always be carried out in the presence of the user. The user should be sitting
upright in the wheelchair while making adjustments.
All parts of the product should be cleaned thoroughly before adjustments are made.
The tools required for adjustments and maintenance tasks as well as the torque values for screw connections are
listed in the section "Appendices" (see page 41).
7.2 Basic functions
7.2.1 Adjusting the seat depth
1) Loosen the wing nuts on the underside of the seat (see fig. 74, item 1).
2) Adjust the seat depth by moving the leg support (see fig. 75).
3) Firmly tighten the wing nuts.
Adjusting the depth of the hip supports
1) Remove the cover from the support.
2) Loosen the screws in the slotted holes on the sides (see fig. 76) and adjust to the desired depth.
3) Tighten the screws and put on the cover.
74
75
76
7.2.2 Adjusting the seat width
1) Loosen the wing nuts on the underside of the seat (see fig. 77, item 1).
2) Adjust the seat width by moving the hip supports (see fig. 78). Abducted settings are possible as well.
3) Firmly tighten the wing nuts.
31
Kimba
Settings