42
43
c) Mounting the crotch belt
1) Thread the crotch belt (see fig. 39, item 9) with the proper side through the front slot of the seat plate (see
fig. 44, item 1).
2) Thread the crotch belt twice through the stop plate (see fig. 39, item 10) and back up through the seat plate
(see fig. 44, item 2).
3) Thread the crotch belt through the adjustment clasp again (see fig. 45, item 1).
44
45
d) Finishing the assembly
1) Trim excess belt ends if necessary.
2) Seal the loose ends by applying heat (e.g. with a lighter).
→
If the buckle (see fig. 39, item 9) can be closed when it lies in the centre of the seat, the five-point belt has
been mounted properly.
6.2.3.3 Harness for the upper body
WARNING
Incorrect application of the belt
Throttling, suffocation or strangulation due to sliding forward or down in the product
►
Always use the positioning system in combination with a positioning groin strap that has been put on and
adjusted correctly to stabilise the pelvis.
►
The positioning system must fit closely but not too tightly. To avoid injury to the user, it should be possible to
slide two fingers comfortably between the positioning system and the upper body.
►
The positioning system is intended to support the area of the upper body from the front. It must be put on and
positioned in such a way that the neck and the throat area remain free at all times. Follow the positioning
instructions.
►
To put the product on and adjust it correctly, follow the information in these instructions for use so that the
user cannot slide into a hazardous position.
INFORMATION
Note the instructions for use and possible application errors (see page 18, four-point belts), which apply here too.
21
Kimba
Installing options/accessories
