23
24
6.2.2.2 Two-point lap belt with plastic buckle
25
1 Two-point lap belt
3 Three-slot mounting brackets, 50 mm
2 Mounting material
Mounting the two-point lap belt
1) Mount the three-slot mounting brackets (see fig. 25, item 3) at the bore holes on the bottom of the seat plate
(see fig. 26).
INFORMATION: It should be possible to turn the three-slot mounting brackets with some resistance if
needed.
2) Turn the three-slot mounting brackets to the outside.
3) Lay the two-point lap belt on the seat.
4) Guide the ends of the belt sideways under the hip supports (see fig. 27, item 1).
With adjustable arm supports:
Guide the belt ends behind the arm support holder (see fig. 27, item 1).
5) Thread the ends of the belt through the three-slot mounting brackets (see fig. 28). Adjust the belt length and
tighten the belt.
6) If necessary, cut off protruding belt ends and seal the loose ends by applying heat (e.g. with a lighter).
14
Installing options/accessories
Kimba
