Otto Bock Kimba Cross, Instructions For Use Manual

Page: 44 / 152

44
4.3.3 Equipment package required according to German Motor Vehicle Traffic Reg-
ulations
(StVZO)
, Accessories for bicycle trailer (fig� 32)
Reflectors:
Attach the two red reflectors with the tube clamps to the rear crosstube (Fig. 33). (As an alterna-
tive to a second red reflector a combination of rear light plus reflector may be included with the
Kimba Cross.) Attach the two white reflectors at the front of the Kimba Cross to the deflector
angles using adhesive tape (Fig. 34, item A).
Rear light:
The battery-operated rear light should also be attached with tube clamp(s) to the rear crosstube
(Fig. 33, item A).
(As an alternative to a second red reflector a combination of rear light plus reflector may be
included with the Kimba Cross.)
Roll Bar:
Mount the roll bar as shown in Fig. 35.
Signal Pennant:
Loosen the left cap nut of the pushbar bearing (Fig. 36, item A), insert the fork of the fiberglass
rod (Fig. 36, item B) behind the washer and snugly re-tighten the cap nut.
5 Multifunctional Seating Unit
(Depending on the scope of delivery)
5.1 Mounting
• Bring the backrest (Fig. 37, item B) in upright position and fix it in the desired position by
tightening the clamping lever (Fig. 38, item E).
• When pulled away from the screw, the clamping lever can be rotated freely, thus enabling
you to turn it to a more convenient operating position.
• Slide the back insert (Fig. 38, item B) into the back base (Fig. 38, item D) and clamp it in the
desired height by tightening the set screws (Fig. 38, item C).
• We recommend adjusting the seating unit as directed before mounting the padding (please
refer to section Adjustment and Adaptation Possibilities of the Seating Unit).
• Place the seat padding (Fig. 39) onto the seat so that the corresponding hook & loop straps
are connected. Allow the seat padding to extend approx. 2 cm over the back of the seat edge.
• Adjust the desired depth of the hip support retainers and fix each with the two adjustment
screws (Fig. 40).
• Slide the hip support pads over the retainers and attach with hook & loop straps (Fig. 41).
• Put the lateral support pads (Fig. 42, item A) onto the plastic retainers with the padding side
towards the inside and secure them with the hook & look closures.
• Pull the back padding (Fig. 38, item A) with its cap over the back insert and close the zipper.
Slightly press the padding against the back insert from top to bottom so that the hook & loop
closure on the padding (Fig. 42, item B) and back insert closes. Pull the excess back padding