Otto Bock Ipso Cast 743G15, Instructions For Use Manual

Page: 25 / 100

25
6 Cleaning
CAUTION
Failure to follow the instructions for disinfection or cleaning
Health hazard due to contact with pathogens and damage to the product
►
Observe all instructions in this document.
Cleaning the casting tube
►
Rinse the casting tube thoroughly with water immediately after use to remove plaster residues.
►
Then dry the metal ring with a clean cloth and allow the casting tube to air dry (do not use a
heater or other heat sources!).
Cleaning light soiling
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
Cleaning heavier soiling
> Required materials: cleaning cloth, 634A58 isopropyl alcohol, soft cloth
►
NOTICE!
Verify material compatibility.
Clean the product with a cleaning cloth and isopropyl alcohol.
►
Dry the product with a cloth.
Cleaning with Disinfectants
> Required materials: colourless, alcohol-free disinfectant (verify material compatibility!), soft
cloth
►
Disinfect the product with the disinfectant.
►
Dry the product with a cloth.
►
Allow to air dry in order to remove residual moisture.
7 Disposal
This product may not be disposed of with regular domestic waste in all jurisdictions. Disposal that
is not in accordance with the regulations of the country where the product is used may have a det­
rimental impact on health and the environment. Please observe the information provided by the
responsible authorities in the country of use regarding return, collection and disposal procedures.
8 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.