Otto Bock Genium 3B1-2, Instructions For Use Manual

Page: 96 / 480

96
Error message Cause Correction
Component was con­
nected to another
device. Establish con­
nection?
The component was
connected to another
device/remote control. To disconnect the original connection, tap
the "
OK
" button.
If the original connection is not to be dis­
connected, tap the "
Cancel " button.
A current connection to
the prosthesis was inter­
rupted. Check the following points:
•
Distance from the prosthesis to the
device
• Battery charge level of the prosthesis
• Bluetooth on the prosthesis switched
on? (see Page 79)
• If multiple prostheses were stored in
the remote control, was the correct
prosthesis selected?
17.2.4 Status signals
Battery charger connected
LED on
power
supply Status
LED on
battery
charger Event
Power supply and battery charger operational. Battery charger not yet
connected to receiver.
Battery charger connected to receiver, good connection.
This display turns off automatically after approximately one minute to
avoid bothersome light at night. The charging process is not affected.
Battery charger disconnected
Beep
signal Vibration
signal Event Resolution
1x short 1x short Self-test completed successfully.
Product is operational.