3.11.5 Replacing the Caster Fork
1) Loosen/remove the size 19 hexagon nut inside the caster fork (see fig. 121).
2) Remove the caster fork from the threaded stud (caster axle) and replace it.
3) Set the caster fork onto the threaded stud.
4) Retighten the hexagon nut to
25 Nm
.
5) Make sure that the threaded axle (see fig. 122, item 1) is firmly connected to the caster attachment device (see
fig. 122, item 2). The mounting screw (see fig. 122, item 3) must be secured with Loctite® 241 (medium
strength) and tightened to
8 Nm
.
121
122
3.11.6 Replacing the Eccentric Disc
1) Unscrew/remove the Allen head screw on the eccentric (see fig. 123).
2) Remove/replace the eccentric disc.
3) To reassemble, perform these steps in reverse order. Tighten the screw connections to
6 Nm
.
123
3.11.7 Retrofitting the Caster Fork System Frog Legs (spring-mounted)
1) Unscrew/remove the caster head mounting on the frame (2x size 6 Allen head screws) (--- FEHLENDER LINK -
--).
2) Remove the caster head adapter and the caster head.
3) Install the frog legs installation unit (caster head, frog legs caster fork: see fig. 124) on the frame using 2 size 6
Allen head screws. In doing so, install the longer screw in the rear in travel direction.
4) Tighten the Allen head screws to
6 Nm
.
5) Finally, adjust the caster wheel journal angle (see fig. 125; see Page 33).
36
Service Work
Avantgarde CV / CS / CLT
Summary of Contents for Avantgarde CLT
Page 1: ...Service manual Avantgarde CV CS CLT...
Page 61: ...61 Avantgarde CV CS CLT...
Page 62: ...Avantgarde CV CS CLT 62...
