86
Parameter
Adjustment
software
range
Setting
range, app
Meaning
Basic flex.
0–200
+/- 20
Level of flexion resistance at the start
of flexing the knee joint
Gain
0–100
+/- 10
Increase in flexion resistance (starting
with the parameter "
Basic flex.
")
when flexing the knee joint. The knee
joint locks at a certain flexion angle,
which depends on the setting of the
parameters "
Basic flex.
" and "
Gain
".
Basic ext.
0–60
+/- 20
Level of extension resistance
Locking angle
0–90
+/- 10
Angle up to which the knee joint can
be extended.
Information:
If this parameter is >0,
the knee joint is locked in a flexed
position in the extension direction. To
unlock it, unload the prosthesis and
tilt it back for at least 1.5 seconds.
This makes extension of the joint pos
sible independently of the settings for
the parameters "
Basic ext.
" and
"
Locking angle
". This may be neces
sary to switch to basic mode using a
movement pattern.
Pitch
1000 Hz–
4000 Hz
1000 Hz–
4000 Hz
Pitch of beep signal for confirmation
tones
Volume
0–4
0–4
Volume of beep signal for confirma
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud
ible feedback signals. However, warn
ing signals in case of errors are still
generated.
9.3 Turning Bluetooth on the prosthesis on/off
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 86).
INFORMATION
Basic mode (mode 1) has to be active to turn off Bluetooth. If a MyMode is activated, one has to
switch to basic mode to turn off Bluetooth.
