10.1 Switching MyModes with the cockpit app
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see Page 96).
INFORMATION
If the
Volume
parameter is set to '0' in the Cockpit app (see Page 93) or if mute mode (silent mode) is activated,
there are no beep signals.
Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
1
2
3
Product
change
2. Golf
1. Basic Mode
1. Basic Mode
100%
1) Tap the symbol of the MyMode (1) you want in the main menu of the
app.
→
A security question for changing the MyMode appears.
2) If you want to change the mode, tap the "
OK
" button.
→
A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→
The current mode is also indicated by the name on the lower edge
of the screen (3).
10.2 Switching MyModes using motion patterns
INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
INFORMATION
If the
Volume
parameter is set to '0' in the Cockpit app (see Page 93) or if mute mode (silent mode) is activated,
there are no beep signals.
Information on switching
•
Switching and the number of motion patterns must be activated in the adjustment software.
•
Before the first step, always check whether the selected mode corresponds to the required motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
•
Switching using motion patterns has to be enabled in the adjustment software.
•
Position the prosthetic leg back slightly and bounce on the forefoot with the leg extended while maintaining
constant contact with the floor.
•
Weight must be placed on the forefoot while bouncing.
•
The load may not be taken off the foot fully when relieving the load.
98
MyModes
Summary of Contents for 3B1-2/3B1-2-ST
Page 62: ...62 ...
Page 115: ...115 ...
