Ottobock | 5
10S18=40
1
2
Insert the lamination ring (1) with cover (2). The cover must be flush with
the socket! Let the adhesive joint harden.
6 Mounting the Adapter Piece
3
4
Undo the cover. Screw in the adapter piece (3) with counter nut (4).
Hand-tighten the counter nut 709Z9 Special Tool.
3
4
Note: To ensure a secure assembly of the Electrohand 2000, the contact
surfaces of adapter piece (3) and counter nut (4) must be absolutely
flush with each other.
Attention:
Only use 709Z9 Special Tool for tightening the counter nut. The counter nut may become
damaged when tightening in the vise or for example with pliers.
7 Liability
Otto Bock Healthcare Products GmbH, hereafter referred to as manufacturer, assumes liability
only if the user complies with the processing, operating and maintenance instructions as well
as the service intervals. The manufacturer explicitly states that this product may only be used in
combination with components that were authorized by the manufacturer (see instructions for use
and catalogs). The manufacturer does not assume liability for damage caused by component
combinations which it did not authorize.
