20w Marietta Floor Lamp
20M15BZD-SHPR 9931
CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology
with your new OttLite
®
product.
STEP 1: PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form
and return it today by mail, or register online by going to:
www.ott-lite.com/warranty.
WARNING:
To prevent electric shock, make sure the lamp
is not plugged in until all assembly steps are complete.
STEP 2: LAMP ASSEMBLY
1.
Make sure the lamp is not plugged into an electrical
socket.
2.
Unpack all lamp parts and lay out on the floor with the
base (A) lying flat.
3.
Thread middle pole (C) to upper pole (D) by hand,
turning clockwise until tight.
4.
Thread lower pole (B) to middle pole (C) by hand,
turning clockwise until tight.
5.
Thread lower pole (B) to base (A) by hand, turning
clockwise until tight.
6.
If installed, remove socket ring (F) from socket
assembly (G).
7.
Place shade (E) on socket assembly (G).
8.
Secure shade (E) in place by threading socket ring (F)
onto socket assembly (G) and firmly tighten by hand.
9.
Install bulb following
BULB INSERTION/
REPLACEMENT
instructions.
10.
Plug the lamp into a standard 120V outlet.
11.
Adjust shade height and angle by turning thumb levers
(J, K) counterclockwise to loosen, reposition shade (E)
then turn thumb levers (J, K) clockwise to tighten.
Turn lamp on or off by rotating the switch (L) located on the
socket clockwise.
STEP 3: BULB INSERTION/REPLACEMENT
1.
Make sure the lamp is not plugged into an electrical
socket.
2.
If the lamp has been in use, allow it to cool
approximately 5 minutes before proceeding.
3.
To install a bulb (M) in the socket, grasp the bulb
firmly in your hand and push the bulb straight into the
socket by applying pressure to the base of bulb, until it
“snaps” into place. Do not apply pressure to the glass
end of the bulb.
4.
To remove a bulb (M) already installed in the lamp,
grasp it firmly in your hand and pull it straight out
of the socket. Do not twist or turn the bulb while
removing it from the socket.
5.
Turn lamp on or off by rotating the switch (L), located
on the socket, clockwise.
Please note that in operation, OttLite
®
bulbs are not
dimmable.
Enjoy your OttLite
®
Marietta Floor lamp!
This lighting system is designed for use with OttLite
®
Type
tubes (Style Number SB20-M). Use of other
products voids the warranty and may result in damage
to the lighting system.
CAUTION!
If the external flexible cable or
cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or its service agent or a
similar qualified person in order to avoid a hazard. Indoor
use only.
To prevent electric shock,
match wide blade of plug to
wide slot, fully insert.
CAUTION! ImpOrTANT
sAfeTy INsTrUCTIONs:
This portable lamp has a polarized plug (one blade is wider
than the other) as a feature to reduce the risk of electric
shock. This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. Never use
with an extension cord unless plug can be fully inserted.
Do not alter the plug.
English
20w Marietta Floor Lamp
INS120044 REV110612
K
D
C
B
A
L
G
E
M
F
J
G
