LED Desk Organizer Lamp
A12G59-FFP
GX8280
CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology with
your new OttLite
®
product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and
return it today by mail, or register online by going to:
OttLite.com/warranty
NOTE: THIS UNIT IS FULLY ASSEMBLED
1.
Remove lamp from packing placing lamp body base
(A)
flat
on a steady surface.
2.
Connect the AC Adapter input
(E)
into connector
(F)
in the
rear-bottom of the lamp.
3.
Plug the A/C adapter
(H)
into a standard household 120V
AC outlet.
Note: Only use with the supplied AC adapter
to avoid damage or fire.
4.
Turn the lamp ON & OFF using power switch
(B)
located in
the front side of base
(A)
near storage area. Power switch
(B)
is a “touch” switch that controls the dimmer function for
4 levels of brightness.
5.
To power LED settings, slightly touch the switch to achieve
the following:
» turn lamp “ON” to 1st brightness setting; touch the
switch “once”;
» for 2nd brightness setting; touch the switch
“two-times”;
» for 3rd brightness setting; touch the switch
“three-times”;
» for 4th brightness setting; touch the switch
“four-times”;
» to turn lamp “OFF”; touch the switch “five-times”.
6.
To position the shade simply bend the flex-neck
(G)
as
needed to point the light. Please hold the lamp base
(A)
while adjusting the lamp. Take care not to overextend the
lamp to avoid unbalancing it and damage.
Enjoy your OttLite
®
LED Desk Organizer Lamp!
SAFETY WARNING:
TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
1.
Turn lamp off and
WAIT UNTIL LAMP HEAD
(C) and
ADAPTER
(H)
ARE COOL before handling.
2.
The LED panel
(D)
might get hot after several hours of
continuous use,
DO NOT
place your hands directly on
LED light panel.
3.
Never use with an extension cord unless the plug can be
fully inserted into the receptacles in the extension cord.
4.
Do not alter the plug.
5.
The lamp head included with this unit cannot be replaced by
the consumer.
NOTE:
The important safety instructions appearing in
this instruction sheet are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution, and care must be
used with any electrical product.
CAUTION!
IF THE ExTERNaL FLExIbLE CabLE OR CORD OF
THIS LUmINaIRE IS DamagED, IT SHaLL bE ExCLUSIvELY REPLaCED bY
THE maNUFaCTURER OR ITS SERvICE agENT OR a SImILaR qUaLIFIED
PERSON IN ORDER TO avOID a HazaRD. INDOOR USE ONLY.
FCC PART 15
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
»
Reorient or relocate the receiving antenna.
»
Increase the separation between the equipment and receiver.
»
Connect the equipment into an outlet on a circuit different from
that of the receiver.
»
Consult the dealer or an experienced radio/TV technician
for help.
CAUTION:
Any change or modification to product
not expressly recognized by OttLite Technologies voids
OttLite’s responsibility for proper function of product.
CAN ICES-3 (B) / NMB-3 (B)
AC/DC ADAPTER
Input: AC 100-240V, 50/60 Hz, 0.2A
Output: 12V DC, 0.42A with a Male DC Plug
English
LED Desk Organizer Lamp
INS150201
REV082115
G
D
E
F
H
A
B
C
