INS90011 REV041709
571PN3
Rechargeable Task Lamp
571PN3
B
A
F
M
D
E
K
H
G
N
J
L
C
CONGRATULATIONS!
You’ve purchased the
finest in natural lighting technology with your
new OttLite
®
product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration
Form and return it today by mail, or register online
by going to: www.OttLite.com/warranty.
BE SURE TO READ AND UNDERSTAND
BATTERY
CAUTIONS
AND
BATTERY MAINTENANCE
COMPLETELY BEFORE USING LAMP.
WARNING: To prevent electric shock, make
sure the lamp is not plugged in until all assembly
steps are complete.
INSTALLATION INSTRUCTIONS:
NOTE:
AC means alternating current, which is
available via wall outlet. DC means direct current,
which is provided via battery.
1.
Remove all packaging from the lamp, including
tube and scratch protection wrappings.
2.
Remove the diffuser (A) by holding the shade (C)
and pull down on the end of the diffuser. The diffuser
is held in place at 4 places and snaps in or out of
holding slots. Squeezing the shade slightly at the slot
locations will aid in removal.
3.
Remove tube (B) from packing and install into
lamp socket inside shade (C), by aligning tube base
with socket then push firmly until it snaps into place.
Do not twist or turn the tube.
4.
Give a gentle pull on the tube to confirm it is being
held by the socket.
5.
Reattach diffuser (A) to shade (C) by aligning the
holding tabs with the holding slots and pressing to
snap into place.
6.
Referring to diagram (G), move the AC/DC switch
to the AC position.
7.
Refer to OPERATING INSTRUCTIONS to
fully charge battery BEFORE FIRST USE
and after EVERY USE.
8.
Refer to TUBE INSERTION/ REMOVAL for future
change out of tube.
OPERATING INSTRUCTIONS:
NOTE:
This product is intended for indoor use only.
NOTE:
Battery must be fully charged before first use
and after every use to maximize battery life and lamp
run time.
IMPORTANT SAFETY NOTICES:
• Never have lamp powered on when closed.
• The lamp must be positioned upright while
charging.
• The lamp must not be placed on its side or
tilted when in use.
1.
Charging the battery:
a.
The battery will be charging any time the lamp
is connected to a 120V AC outlet as directed
below. Refer to diagram (G) as needed.
b.
Connect the AC Adapter (H) to a standard 120V
AC outlet and to the 9V DC connector (E).
c.
Rotate the shade (C) to its closed and off
position. The battery charges faster when the
lamp is off.
2.
Using the Lamp with wall power:
a.
See diagram (G) as needed.
b.
Connect the AC Adapter (H) to a standard 120V
AC outlet and to the 9V DC connector (E).
c.
Move the AC/ DC switch to the AC position.
d.
Rotate shade to an open position and press on/
off button (F).
e.
If the AC/ DC switch is moved to the DC position
the lamp will turn off, this is normal.
CAUTION:
AC pOwer sUpply reqUIres prOper veNTIlATION fOr prOper OperATION. A
mINImUm Of 6 INChes Of AIr spACe mUsT be prOvIded ON All sIdes exCepT where plUgged
INTO AN eleCTrICAl OUTleT.
When charging the lamp, the lamp must be in an upright position on its base. Failure
to charge in this position can damage the battery or cause a potential hazard due to the
construction of the sealed lead acid battery.
CAUTION – Risk of Injury. Charge only Lead-Acid rechargeable battery rated 6V, 5.0Ah or
equivalent. Other types of batteries may burst causing damage or injury to persons.
SAVE THESE INSTRUCTIONS
|
LAMP CONTAINS MERCURY,
manage in accordance to disposal laws.
ImpOrTANT sAfeTy INsTrUCTIONs
WARNING – When using electric appliances, basic precautions should always be followed,
including the following:
a) Read all the instructions before using the appliance.
b) To reduce the risk of injury, close supervision is necessary when an appliance is used
near children.
c) Only use attachments recommended or sold by the manufacturer.
d) Do not use outdoors.
e) To reduce the risk of electrical shock, do not put rechargeable light in water or other
liquid. Do not place or store appliance where it can fall or be pulled into a tub or sink.
f) For an appliance with a replaceable tube – Always unplug before replacing the tube.
Replace tube with same type rated 13 Watts.
CAUTION! ImpOrTANT sAfeTy INsTrUCTIONs:
ThIs pOrTAble lAmp hAs A pOlArIZed plUg (ONe blAde Is wIder ThAN The OTher) As A feATUre TO
redUCe The rIsK Of eleCTrIC shOCK. ThIs plUg wIll fIT IN A pOlArIZed OUTleT ONly ONe wAy. If The
plUg dOes NOT fIT fUlly IN The OUTleT, reverse The plUg. If IT sTIll dOes NOT fIT, CONTACT A qUAlIfIed
eleCTrICIAN. Never Use wITh AN exTeNsION COrd UNless plUg CAN be fUlly INserTed. dO NOT AlTer
The plUg.
CAUTION:
TO preveNT eleCTrIC shOCK, mATCh wIde blAde Of plUg TO wIde slOT, fUlly INserT.
