Page 13
30
45° angle
8”
33”
23”
16”
33”
23”
33”
33”
22. Slide the tent over the main frame bar
assembly, then fasten the velcro straps
on the inside of the tent to each main
frame bar.
Tent
Main Frame
Assembly
Note:
Collapsing
the center and front
main frame poles
part way down
will make installa-
tion easier.
45° angle
23. Once the canvas is on the frame and the Velcro attached, extend all of the frame bars upward and make sure all of
the support poles are installed. Extend the front adjustable support pole so that the fabric in front is snug and not
sagging. It will be necessary to loosen the back adjustable pole to achieve this. Once the front is set and the top
support poles are in place, the back adjustable pole can be extended until it is snug. Install the plastic trim lock in
the positions shown below.
Install the back center trim lock fi rst and work your way around the sled, pulling the fabric snug as you go. The
canvas will be trapped between the sled lip and the trim lock, and will also wrap underneath the sled lip providing
a very good seal. Check the fi t of the canvas and adjust as necessary before installing the screws (Item 29) to hold
the trim lock (Item 30) in place. Use three screws on the long pieces and two screws on the shorter pieces.
Attach the eight plastic trim locks (Item 30) to the sled in the locations shown with the 45° angled edge to the
inside of the sled.
