English
Mounting instructions
Bubble pot
EPS 50
OTT Hydromet GmbH
P.O. Box 2140
⋅
87411 Kempten
Ludwigstrasse 16
⋅
87437 Kempten
Phone++49 831 5617-0
Fax++49 831 5617-209
E-mail: [email protected]
Internet: http://www.ott.com
Dokumentnummer
55.510.048.B.E 03-0411
Subject to technical changes!
Release the conical nut slightly and adjust the bubble pot horizontally (both
axis) and with the direction of the flow.
Tighten the conical nut again.
Maintenance
Regularly check the bubble pot – at least once a year – if there is any debris
and if it is still correctly aligned. If there are lots of particles or weeds in the
water you have to check more frequently.
For cleaning you have to remove the three Phillips screws and the base plate at
the bottom of the bubble pot. For this the bubble pot can, but must not necessa-
rily be detached. Perhaps you have to slightly release the conical nut and to
turn the basin by 180°. After cleaning the bubble pot has to be adjusted again
to the direction of the flow. Attention: the bubble in pressure must be built up
again; see user instruction for Nimbus!
Base plate
Basin
Conical nut
Phillips
screws
Abb. 5: Cleaning of bubble pot
If the bubble pot is completely detached for
cleaning the bubble tube must be cut by 1
cm before it is connected again.
Adjustment range:
±
15
°
Conical nut
Picture 4: Adjust bubble pot
max. tolerance of adjustment
is +/- 5°!
