SJ-20162405182123-002|2016-05-24 (R2.0)
Speedport Entry 2i Maintenance Management Guide
3-18
Figure 3-11 Firewall Page
2. Set the parameters. For a description of the parameters, refer to
Table 3-7 Firewall Parameter Descriptions
Parameter
Description
Firewall Level
l
High
: allows legal access from the WAN but forbids Internet
devices from sending ping packets to the WAN interface of the
Speedport Entry 2i.
l
Middle
(Recommended): allows legal access from the WAN
and blocks dangerous data from the Internet.
l
Low
: allows legal access from the WAN and allows Internet
devices to send ping packets to the WAN interface of the
Speedport Entry 2i.
Enable SPI(IPv6)
To enable SPI (IPv6) protection, select this radio button.
Anti-Hacking
To enable anti-hacking protection and prevent device shutdown due to
Internet attacks, select this radio button.
Select
Internet > Security > The Statistical Information of
Anti-hacking
to go to the Anti-Hacking page.
The page shows the number of times the Gateway actively has
protected your network against each intrusion since the last statistics
reset.
3. Click
Apply
button to apply the changes.
– End of Steps –
3.5.2.
Configure the Filter Criteria
The section describes how to configure filter criteria.
