SJ-20162405182123-002|2016-05-24 (R2.0)
Speedport Entry 2i Maintenance Management Guide
3-10
3.3.
Configure the Ethernet WAN Switch
This page will help you convert LAN1 to WAN interface.
Steps
1. On the main page of the Speedport Entry 2i, select
Internet > Ethernet WAN
to go to
the
Ethernet WAN
page, as shown in
Figure 3-5 Ethernet WAN Switch Page
2. Once radio button is set to
On
and
Apply
button is pressed, LAN1 will reboot and
will work as WAN interface. Otherwise, when
Off
is applied, LAN1 will work as LAN
interface.
3. Click
Apply
button to apply the changes.
– End of Steps –
3.4.
Configure the QoS
3.4.1.
Configure the QoS Global Parameters
The section describes how to configure QoS global parameters.
Steps
1. On the main page of the Speedport Entry 2i, select
Internet > QoS > QoS Global
Configuration
to go to the
QoS Global Configuration
page.
The page is shown in
