English - 5
1. Turn off and unplug iron.
2. Move Steam Lever back and forth to remove debris and minerals from Steam Valve.
This keeps water flowing into the steam chamber.
3. Fill water reservoir with tap water to MAX line.
4. Plug in iron, press Fabric Select Button to select Linen setting and heat until the
indicator light turns solid blue.
5. Turn off and unplug iron. Holding iron over a sink in a horizontal position, press Self-
Clean Button and hold. Water will begin dripping from the steam vents. Slowly rock
iron side to side and front to back for 30 seconds. Dip nose of the iron slightly below
the rear to circulate water. Release Self-Clean Button after one minute.
6. Open fill cap and empty remaining water. Carefully dry soleplate with a towel.
7. Plug in iron and set Fabric setting to Linen and Heat for 2 minutes to dry out
completely. Set Fabric Select Dial to Off, unplug the iron, and allow to cool.
Anti-Calcium System
The iron houses an anti-calcium filter in the reservoir, which eliminates impurities from the
water. This is a permanent system located inside the water reservoir.
To prolong the efficiency of this filter, follow these steps occasionally:
1. Unplug the iron and allow it to cool.
2. Use an easy-pour measuring cup to mix ¾ cup water and 1 teaspoon salt. Pour
mixture into water reservoir.
3. Leave the solution in the water reservoir for 15 minutes, shaking occasionally, and
then empty it.
4. Fill the water reservoir a second time with the salt water solution, shaking
occasionally and empty it again after 15 minutes.
5. Fill the tank with fresh water to rinse and empty.
GCSTCS-412_18ESM4 (LA).indd 5
10/8/18 10:07
