Osstem OSM 2, Instructions For Use Manual

Page: 10 / 44

10
Safety notes
System failure
A total system failure of the OSM2 does not constitute a critical fault.
Intermittent operating mode S3 (4min/10min)
When there is a current consumption of max. 0.8 A for SI-923 and 1.6 A for SI-915 (with pump switched on), the
permissible relative load time is 4 minutes to 10 minutes pause time.
Coolant
The OSM2 is designed for use with physiological saline solution. Use only suitable irrigation fluids and comply
with the medical data and instructions from the manufacturer. Use the W&H irrigation tubing set or accessories
approved by W&H. Coolant bottle or coolant bag can be obtained from a pharmacist.
Sterility of irrigation tubing set
Sterile irrigation tubing sets are supplied with the equipment. These irrigation tubings are disposable articles and
must be thrown away after each treatment! Please note the expiry date and the relevant regulations for disposal
of irrigation tubing.
Rotational energy
Fast deceleration of the bur can, at times, cause the selected torque to be overloaded as a result of the rotational
energy stored in the drive system. We therefore advise compliance with the individual manufacturer's instructions
for use, particularly when adjusting superstructure screws. For safety reasons, these should be screwed in very
carefully by hand, or by using a torque wrench. We would point out that adjusting these screws with an electric
motor represents a potential risk as described above.