One Stop Systems
OSS-PCIe-HIB35x4 | 21
3.6
Connect ATX Power Supply
If you are using an expansion chassis, the power supply is already part of the unit. You can skip this step.
If you are using an expansion backplane, plug-in the ATX power supply cable into the 24pin ATX power connector on the OSS board.
Connect power to the PSU and turn the switch to ON position.
3.7
Power ON the system
Turn ON the main power of the host computer.
Start the computer by pushing the power button.
Upon powering ON the Host system, it will send a sideband signal to the Target card triggering the expansion system to turn ON.
If the expansion unit or the HIB card are not powering ON, check the link cable make sure it is firmly connected. The target and
host card must be fully seated in the PCIe slot in order to work correctly.