One Stop Systems
4U Value 5slot G3 Expansion Unit
60
8.1.4 Card Mode Settings
The interface card is x16-capable and it can be used interchangeably as Host card or Target card as long as the Dip switches are set correctly.
The Dip switch
(SW1)
allows you to change what mode the interface card can be running. When the card is used as host card, all the
dipswitches should be set off position, see photo below.
When using as “Target Card”, set the dipswitches to the following settings, see photo below.
8.1.5 Pin Assignments
Connectors Gen3 PCIe x16 Card Edge Connector
The pins are numbered as shown with side A on the top of the centerline on the solder side of the board and side B on the bottom of
the centerline on the component side of the board.
The PCIe interface pins PETpx, PETnx, PERpx, and PERnx are named with the following convention: “PE” stands for PCIe high speed,
“T” for Transmitter, “R” for Receiver, “p” for positive (+), and “n” for negative (-).
Note that adjacent differential pairs are separated by two ground pins to manage the connector crosstalk
Summary of Contents for OSS-PCIE-4UV-5slot
