One Stop Systems
OSS-KIT-EXP-3500-2M | 10
3.4
Operation
1.
Power up the power supply to the 2-slot backplane. The 3V aux LED will light. NOTE: THE POWER SUPPLY AND 2-SLOT BACKPLANE
WILL NOT POWER UP AT THIS TIME.
2.
Power up the host system. The power and cable LEDs on the cable adapters will light. This powers up the one slot backplane.
3.
The I/O board will start automatically.
3.5
Using any Third-party I/O device
1.
The add-in card or third-party I/O device must be installed in the endpoint slot (expansion slot / downstream port).
2.
Connect the external power source (separate from the host system power supply) to the add-in card or PCIe card device if
necessary.
3.6
Removing the PCIe cable
1.
To remove the cable, press down the green tab and slowly pull the cable out. Or pull the green tab and slowly pull out the cable.
3.7
Force Power ON
1.
Install shunt or jumper on J2 connector to force power on the backplane. This is not required for normal operation.
