2. Attach arm to pole using hardware provided
– thread 1/2” -13 x 1 ¾” hex head cap screw through flat
washer and pole and then through mounting arm, flat washer, lock washer and nut. Tighten nuts to 236 in-
lbs.
3. Attach arm to fixture using hardware provided
– 3/8” – 16 x 1 ¼” hex head bolts and rubber sealing
washers
– through 3/8” mounting holes near rear wiring entrance. Thread bolts through sealing washer
and then through fixture mounting holes as shown below. Then thread arm over bolts and add sealing
washer, lock washer and nut. Tighten nuts to 236 in-lbs.
Square pole
assembly
(Note: also
assembles to
round pole)
