READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. This product is for use with an LED lighting load and supplies up to
10
W of power at factory
programmed current with a voltage between 10.0 VDC and 55.0 VDC in emergency mode for
a minimum of 90 minutes.
2. Make sure all connections are in accordance with the National Electrical Code, Canadian
Electrical Code and any local regulations.
3. To reduce the risk of electric shock, disconnect AC power of the emergency driver and fuse
from fuse holder of the battery pack before servicing.
4. This emergency driver is suitable for factory and field installation.
For field installation, please
see the instructions on page
3.
5. This product is suitable for damp locations where the d
river case temperature is 75°C maximum
and battery pack case temperature is 55°C maximum.
6. Do not use for outdoor applications.
7. Product is not suitable for heated air outlets and wet or hazardous locations.
8. Do not install near gas or electric heaters.
9. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
10. Do not use this product for other than intended use.
11.
Equipment should be mounted in locations and at heights where it will not readily be subjected
to tampering by unauthorized personnel.
12. Servicing should be performed by qualified service personnel.
13. Use caution when servicing batteries.
SAVE THESE INSTRUCTION
THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM
BATTERY. THE BATTERY MUST BE RECYCLED OR DISPOSED
PROPERLY.
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
OTi30W Self Test Slim Emergency Driver
Installation and Troubleshooting Guide - PN: 57414
