Osram OT EASY 32 CC, Fitting Instructions

Page: 2 / 3

Page 2 of 3
Installation (cont.)
8,5-9,5 mm
16 mm
8,5-9,5 mm
16 mm
8,5-9,5 mm
M
N
O
P
C
H
4
C
H
3
C
H
2
C
H
1
S
EC
35
0
m
A
/C
h.
SE
LV
-
eq
uiv
.
E
A
S
Y
sig
na
l
12
0-2
40
V
50
/6
0
H
z
P
R
I
DO NOT
USE
SE
LV
-
eq
uiv
.
L
Connecting the control unit
Notes
• Max. line length to LED modules: 10 m
• Line cross-sections and cable diameters/sizes:
Connection Line cross-
section
Cable diameter/
size
Power supply 0.5 – 1.5 mm² 7 – 11 mm
External
pushbutton
0.2 – 0.5 mm² 3.2 x 5.2 mm
EASY signal – 2.2 x 4.7 mm
LED modules 0.5 – 1.5 mm² 7 – 11 mm
• Only use LED series circuits at every LED output.
• Only use LED modules/fixtures with separated anodes and
cathodes.
• The maximum number of LEDs that can be connected in se-
ries to each output channel is limited by the forward voltage
V
f
of the individual LEDs, the control unit output voltage and
the cable voltage drop (e.g. V
f
= 3,5 V à max. 6 LEDs). De-
tails on the limitations can be found in the OPTOTRONIC
®
technical instructions.
• A different number of LEDs per channel (not more than the
max. number each) is allowed. Automatic load detection is
performed at power-on.
• To be able to use the colour/colour temperature algorithm of
EASY Color Drive and EASY Hybrid Remote, channels and
LED types are assigned as follows:
Channel RGB+W WW / CW
(Tunable White)
CH1 Red Warm white
CH2 Green Warm white
CH3 Blue Cold white
CH4 White/amber Cold white
• In combination with other types of EASY control units,
4-channel tunable white configurations require to set one
OT EASY 32 CC as master.
• Master-slave connection: Max. 1 master and 15 slaves con-
nectable, see “Connecting the inputs”.
Connecting the inputs
 Connect the 4p4c modular connector (N) of the EASY signal
line.
‚ Strip the power cable (M), remove the insulation from the
phase and neutral conductors and connect to the terminals.
ƒ Connect the line of the external pushbutton to the terminals,
if applicable, or insert the short circuit bridge (O) for slave
mode. Lead external push-button cable and EASY signal ca-
ble together (overlapped) through one opening (L) to ensure
a correct cable clamping function.
„
Use cable clamps.
Insulate the cable PE conductor, if necessary.
Connecting the outputs
 Strip the 4-wire lines (P), remove the insulation and connect
to the terminals. Do not connect the terminals labeled “DO
NOT USE”.
‚ Use cable clamps.