SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31215918
3-13
Arm Guards (If Equipped)
If the machine is equipped with electronic arm guards, the platform
will stop lowering at a predetermined height and the machine’s bea
-
cons will flash at a different rate to warn ground personnel. Machine
lowering can continue after a three (3) second delay. Once the lowering
function is re-engaged an audible alarm will sound. After a three sec
-
ond delay the platform will continue lowering.
Overload Indicator (LSS)
The Overload Indicator indicates when the plat
-
form has been overloaded. An audible alarm will
also signal when the platform is overloaded.
NOTE:
If the Overload Indicator is illuminated all
platform functions will be prevented.
Fully lower the platform from the ground controls or using the
machine manual descent control. Reduce the weight in the plat
-
form to not exceed the rated workload indicated on the capacity
decal.
NOTE:
When ambient temperatures are below freezing, the LSS will
have a reduction in available capacity. This will trigger the LSS
before achieving the maximum allowable capacity.
Tilt Indicator Warning Light and Alarm
A red warning light on the control panel illumi
-
nates and an audible alarm sounds when the
chassis is at or beyond the tilt cutout settings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLATFORM IS
RAISED LOWER PLATFORM AND DRIVE TO A SMOOTH, FIRM SURFACE WITHIN THE
LIMITS OF THE MAXIMUM OPERATING SLOPE.
Horn
This push-button switch, when pressed, permits
the operator to warn job site personnel when the
machine is operating in the area.
Battery Charge Indicator
The battery charge indicator displays the cur
-
rent charge status of the onboard batteries.
•
Red LED flashing = batteries depleted
•
Red LED on solid = batteries low
•
Red LED on and green LEDs on =
batteries full charge
To
order go
to
Discount-Equipment.com
