Oshkosh JLG 1043, Operation & Safety Manual

Page: 129 / 254

Section 5- Attachments
5 - 1 31211368
SECTION 5 - ATTACHMENTS
5.1 APPROVED ATTACHMENTS
Coupler Mounted Attachments
To determine if an attachment is approved for use on specific telehandler you are using,
perform following prior to installation.
• The attachment type, weight and dimensions must be equal to or less than the data
shown on a capacity chart located in the operator cab.
• The model on the capacity chart must match the model telehandler being used.
• Hydraulically powered attachments must only be used on machines equipped with
auxiliary hydraulics.
• Hydraulically powered attachments that require auxiliary electrics must only be used
on machines equipped with auxiliary hydraulics and electrics.
• The attachment is clearly labeled in accordance with ANSI/ITSDF B56.6
If any of the above conditions are not met, do not use attachment. Telehandler may not
be equipped with proper capacity chart or attachment may not be approved for the
model telehandler being used. Contact JLG or a local distributor for further information.
JLG Supplied Fork Mounted Attachments
To determine if an attachment is approved for use on specific telehandler you are using,
perform following prior to installation.
• The machine is authorized for use with JLG supplied fork mounted attachments.
• The model on the capacity chart must match the model telehandler being used.
• Hydraulically powered attachments must only be used on machines equipped with
auxiliary hydraulics.
• Hydraulically powered attachments that require auxiliary electrics must only be used
on machines equipped with auxiliary hydraulics and electrics.
If any of the above conditions are not met, do not use attachment. Telehandler may not
be equipped with proper capacity chart or attachment may not be approved for the
model telehandler being used. Contact JLG or a local distributor for further information.
For requirements regarding fork mounted attachments, see “Fork Mounted Attachments”
on page 5 - 4.
Non-OEM Fork Mounted Attachments
JLG authorizes the use of non-OEM fork mounted attachments provided the criteria and
instructions are followed. See
“Fork Mounted Attachments” on page 5 - 4.
https://www.forkliftpdfmanuals.com/