Section 4- Operation
4
-
10
31211368
Placing a Load
Before placing any load be sure that:
• Landing point can safely support weight of the load.
• Landing point is level; front to back and side to side.
• Use capacity chart to determine safe boom extension range. See
• Align forks at level the load is to be placed, then position boom slowly until load is just
above area where it is to be placed.
• Lower the boom until the load rests in position and the forks are free to retract.
Disengaging a Load
Once the load has been placed safely at the landing point, proceed as follows:
1. With forks free from weight of load, boom can be retracted.
2. Lower carriage.
3. Telehandler can now be driven from landing location to continue work.
https://www.forkliftpdfmanuals.com/