Oshkosh Corporation JLG E300AJ, Operation And Safety Manual

Page: 79 / 92

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121252 – JLG Lift – 6-9
6.3 OPERATOR MAINTENANCE
NOTE: The following numbers correspond to those in Figure 6-
1., Operator Maintenance and Lubrication Diagram.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION
UNDER NORMAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT
OPERATIONS AND/OR EXPOSED TO HOSTILE ENVIRONMENTS OR CON-
DITIONS, LUBRICATION FREQUENCIES MUST BE INCREASED ACCORD-
INGLY.
1. Swing Bearing
Lube Point(s) - Remote Fitting
Capacity - A/R
Lube - BG
Interval - Every 3 months or 150 hrs of operation
Comments - Apply grease and rotate in 90 degree
intervals until bearing is completely lubricated
Table 6-14. Lubrication Specifications.
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of
350 degrees F. Excellent water resistance and adhesive qual-
ities; and being of extreme pressure type (Timken OK 40
pounds minimum).
EPGL Extreme Pressure Gear Lube (oil) meeting API Service Clas-
sification GL-5 or Mil-Spec Mil-L-2105.
HO Hydraulic Oil. Mobil DTE-11M
BG* Bearing Grease (JLG Part No. 3020029) Mobilith SHA 460.
*MPG may be substituted for these lubricants, if necessary, but service
intervals will be reduced.