Oshkosh Corporation JLG 260MRT, Service Maintenance Manual

Page: 63 / 106

SECTION 2 - PROCEDURES
3121801 – JLG Lift – 2-41
2.22 MACHINE CONFIGURATION
PROGRAMMING INFORMATION
NOTE: When configuring a MRT scissors machine, the
machine configuration must be completed before
any personality settings can be changed. Changing
the personality settings first and then changing the
model number of the machine configuration will
cause the personality settings to return to default val-
ues.
Table 2-12. Machine Configuration Programming Information
Configuration Digit Number Description Default Number
1
(Model #)
0
260 MRT 0
2
(Engine Type)
0
1 750 Dual Fuel
905 Diesel
0
3
(Tilt Configuration)
0
1
2
CE W/O CUT - Defalut setting for CE machines. Tilt anle is 3 degree side to side, 5 degree front
to back.
DOM/CSA W/ CUT - Cutout lift up and drive if tilted and elevated. Required for CSA market.
Tilt angle is 3 degree side to side and front to back.
LIFTUP & DRIVE - Cutout lift up and drive if tilted and elevated. Required for AUS and BRZ
markets. Optional for DOM and CE markets. Tilt angle is 3 degree side to side, 5 degree front
to back.
0
4
(Drive Cutout)
0
1 No drive cutout switch installed.
Cuts out drive when deck is elevated above a predetermined elevation
(Not available on 260MRT)
0
5
(Control Direction)
0
1 FWD & LIFT up
FWD & LIFT dn (for future use)
0
6
(Leveling Jacks)
0
1 No
Yes
0
7
(Axle Type)
0
1
2 DOM & CE FIXED
DOMESTIC OSC
CE OSCILLATING
0
8
(Function Cutout)
0
1
2 NONE
DRV & LFT UP
ALL FUNCTIONS
0
9
(Load)
0
1
2 NOT INSTALLED
CUTOUT PLT
CUTOUT ALL 0
4150336_E