SECTION 4 - CONTROL COMPONENTS
4-26
31215825
MONARCH BRAND PUMP - Brush Replacement
Motor Assembly - Remove/Install - Reference Marks
Motor/Brush Cover - Remove/Install
Pump Motor - Removal/Installation - Reference Marks
• For reference when reassembling, mark motor cover, housing
and valve body position before disassembling.
1.
Motor Top Cover
4.
Housing/Motor Valve Body
2.
Cover/Housing
Reference Mark
Reference Mark
5.
Motor Valve Body
3.
Motor Housing
3
4
1
2
REMOVE THE MOTOR COVER CAREFULLY, THE (SHORT) POWER LEADS INSIDE THE COVER FROM THE (+/–) POSTS ARE
SOLDERED TO ATTACH CLIPS WHICH ARE FASTENED TO THE BRUSH CARRIER ASSEMBLY WITH SCREWS (ITEM-5). RAISE
THE COVER STRAIGHT UP - REMOVE THE SCREWS - THEN HINGE THE COVER UP (SEE CENTER ILLUSTRATION) AND PRY
THE CLIPS OFF OF THE BRUSH CARRIER ASSEMBLY TO COMPLETELY REMOVE THE MOTOR COVER.
Note:
(a) Once cover screws are removed, you may need to tap lightly around the edge of the top cover to separate it from the motor hous
-
ing.Read the important note above before attempting to remove the cover.
(b) These steel screws are threaded into the aluminum valve body, do not overtighten.
2
3
1
4
5
5
Figure 4-46. Motor/Brush Cover - Removal/Installation
1.
Motor/Brush Cover (a)
2.
Cover Screws (b)
3.
Washers
4.
Power Leads to Lead Clips (Soldered)
5.
Power Lead Clip Attach Screws
Go to
Discount-Equipment.com
to
order your
parts
