SECTION 4 - CONTROL COMPONENTS
4-6
31215825
Battery - Installation - (2-12V Batteries)
To gain access to the batteries, requires opening or removal of
the upper half of the rear covers, see Section 4.2, Controls
Cover Installation.
Procedure for removal is same for both batteries.
On installation, batteries set in machine with the posts to the
inside. Left side battery (–) NEG post at front (shown below),
Right side battery (+) POS post towards machine front.
Note:
(a) Mount with terminal posts inboard.
(b) Apply battery terminal grease to prevent corrosion.
1.
Battery (a)
2.
Hold-Down Bar
3.
Battery Terminal Attach
Nut/Washer (b)
4.
Hold-Down Bar Wing-
nut and Washer
Figure 4-8. Battery Installation (Left Side Battery Shown)
Go
to
Discount-Equipment.com
to
order
your
parts
