SECTION 4 - CONTROL COMPONENTS
4-4
31215825
Platform Control Console Installation
The platform control console is located in the platform and
mounted on the right side platform rail.
For removal see below, for servicing information see Section
4.7, Platform Control Console - Service Procedures.
Horn Installation
Alarm Installation
1.
Console Mounting Bracket and Attach Pin
2.
Platform Control Console
3.
Platform Console to Junction Box Harness (a)
Note:
(a) The other end of this harness is plugged into the plat
-
form junction box mounted to the mast behind the plat
-
form decal board. From the console the harness is tie
strapped to the platform rail, and run inside the mast
through a large hole in the mast to the platform junction
box.
1.
Horn Assembly
2.
Attach Screws/Washers
Note:
See Figure 4-9. for wiring connection instructions.
1.
Alarm Assembly
2.
Attach Screws/Washers
Note:
See Figure 4-9. for wiring connection instructions.
1
2
1
2
Figure 4-4. Platform Control Console - Installation
Figure 4-5. Horn Installation
Figure 4-6. Alarm Installation
Go
to
Discount-Equipment.com
order
your
parts
