SECTION 3 - BASE COMPONENTS
31215825
3-15
Hub Sub-Assembly
Figure 3-15. Hub Sub-Assembly
1.
Put Hub (G2) on a table with the tapped holes facing
down.
2.
Using a flat plate in conjunction with a pressing tool,
press in the Seal (G16) so it is flush with the edge of the
hub.
NOTE:
The Seal has a thin outer shell that can be easily damaged
if not installed with care. It is a good idea to start the Seal
into the bore with a rubber mallet before pressing.
3.
Flip the Hub (G2) over.
4.
Using the appropriate pressing tool (T-174356), press
the Main Bearing (G14) into the bore until it bottoms
out.
Go to
Discount-Equipment.com
to
order your
parts