SECTION 3 - BASE COMPONENTS
31215825
3-11
Input Carrier Disassembly
Figure 3-11. Input Carrier Disassembly
1.
Remove Retaining Rings (G18) from each of the three
Planet Shafts (G6).
NOTE:
Do not overstress these Retaining Rings when removing
them.
2.
Remove Thrust Plate (G23).
3.
Remove Thrust Washer (G25) from each Planet Shaft
(G6).
4.
Slide each Input Planet Gear (G5) off the Planet Shaft
(G6).
5.
Press out Bushing (G26) from the bore of each Planet
Gear (G5). Bushings cannot be reused when removed.
6.
Remove the other Thrust Washer (G25) from each Planet
Shaft (G6).
7.
Remove Retaining Ring (G24) from Output Sun Gear
(G8).
8.
Slide Output Sun Gear (G8) out from the center of the
Input Carrier (G7).
9.
Remove the three Planet Shafts (G6) from the Input Car
-
rier.
NOTE:
The Planet Shafts (G6) are held in with a press fit. To avoid
damage to the parts, use an arbor or hydraulic press to
remove the Planet Shafts (G6).
Go
to
Discount-Equipment.com
to
order
your
parts
