SECTION 5 - MAST COMPONENTS
31215825
5-11
9.
Remove the cylinder/anchor block attach pin - snap ring
from the back of the top of mast section-2.
10.
Remove the cylinder rod pin from the cylinder/chain
anchor block.
11.
At the bottom of mast section-1, remove the cylinder
mount bolts, and mount reinforcement plates.
NOTE:
If mount shims are installed, mark the mast and the shim
to which side the shims came out of for re-installation.
12.
Slide the lift cylinder and mount assembly out of the
bottom of mast section-1 and -2 and place on a suitable
work surface.
Figure 5-8. Snap Ring Installation
1.
Back of Mast Section-2
3.
Pin and Snap Ring
2.
Cyl./Chain Anchor Block
4.
Cylinder Rod
Figure 5-9. Cylinder Rod Pin Installation
1.
Cylinder Rod Pin
3.
Cyl./Chain Anchor Block
2.
Cylinder Rod
3
4
1
2
1
2
3
Figure 5-10. Lift Cylinder Mount Installation
1.
Cylinder/Mount Assembly
3.
Mast Reinforcement Plate
2.
Mount Shims (Mark Shims)
4.
Mounting Screws/Washers (a)
NOTE:
(a) Apply Medium Strength Threadlocking Compound
to threads at final assembly.
Go
to
Discount-Equipment.com
to
order
your
parts
