Oshkosh Corporation IMT CAS80R, Installation, Operation, Maintenance & Parts Manual

Page: 30 / 68

SECTION 5: MAINTENANCE CAS80R
PAGE - 24 Manual # 99905932 (February 2016)
®
IOWA MOLD TOOLING CO., INC.
(641) 923-3711 • www.imt.com
5.2 MACHINE MAINTENANCE
SCHEDULE
Refer to Table 5A: Routine Maintenance
Schedule . A routine maintenance schedule
based on time and/or hours logged, is given
in
Table 5A . The intervals are determined
from machine usage under typical operation
conditions. However, the operator must be
aware that operating conditions will vary
depending on such things as specific
customer
requirements, environmental
temperatures and cleanliness of the ambient
air. With this in mind, the specifications given
in
Table 5A should be used as a guideline
instead of a fixed agenda. A safe approach
to routine maintenance would be to perform
the given maintenance task more frequently
under harsher conditions.
IMT provides a routine maintenance parts list
in
Section 7 , Table 7A . Should a non-routine
part need replacement or servicing, peruse
the various parts list illustrations in
Section 7
to help determine the exact part and part
number in question. Our parts and service
departments are ready to assist in identifying
and/or replacing non-routine parts.
5.3 REPLACEMENT PARTS
Replacement parts should be purchased
through your local IMT representative or
where the compressor system was
purchased. If, for any reason, parts are not
available in this manner, they can be
purchased through IMT directly.
5.4 PARTS REPLACEMENT
AND ADJUSTMENT
PROCEDURES
Most routine maintenance assistance can be
found in the appropriate “Action to Take”
column given for a specific routine
maintenance item. This section is mainly
concerned with non-routine maintenance
items and procedures. For assistance with
any procedure needed beyond what is
presented in this manual, please contact the
IMT Service Department.
CAUTION
Use only original IMT equipment filters.
Other filters may not have correct pressure
rating or may have different thread.
CAUTION
Do not mix oils of different types.
IMPORTANT
Using replacement parts other than
Genuine IMT Replacement Parts will void
the warranty.
NOTE
For assistance when ordering new
replacement parts, consult
Section 7.1,
Parts Ordering Procedure
, and Table 7A:
Recommended Spare Parts List.
Iowa Mold Tooling Co., Inc.
500 Highway 18 West
Garner, Iowa 50438
Phone: 641.923.3711
Fax: 641.923.2424
NOTE
If additional spare parts are being stored
for future use, make certain that they are
stored in proper containers that allow for
protection against contamination, and kept
in a clean area of moderate temperature
reading. For information on storing the
machine package for periods of non-use,
consult
Section 5.5.7, Long Term Storage
.