OPERATING THE LASER
•
The laser can be focused with the aid of a 1/16” dowel pin provided with the laser, or any other similar tool
•
Fit the dowel pin in the notches as shown in the image. A half turn either way will allow you to move the focal
point throughout its focus range from 100mm to infinity
•
NOTE: some lasers (i.e. Micron Focus) have a factory set pre-focus, dowel pin will not be provided
•
As on Option, Laser can be equipped with a trim potentiometer found on back of laser to linearly adjust
intensity from 100% to 0%. Use an appropriate sized flat head screwdriver.
•
Connect to DC power supply
•
The green LED on back of laser
will be ON when the laser is
emitting radiation
•
Connect to ground
•
Can be used for modulation
using an analog signal.
RED LEAD
BLACK LEAD
WHITE LEAD
Clamping area = For optimal performance and lifetime of the laser, fixing the laser using a C-mount bracket (or any
bracket with increased contact area) is recommended. The designated clamping area of the laser can be found on the
mechanical drawing in the Datasheet.
Refer to electronics table in troubleshooting section for operating voltages for your specific laser configuration.
