operating the laSer
•
the laser can be focused with the aid of a focusing tool provided with the laser, or any other similar tool
•
Fit the focusing tool in the notches as shown in the image. this will allow you to move the focal point
throughout its focus range from 100mm to infinity
•
the white lead allows
you to modulate the
laser using a ttl signal.
•
connect to ground.
•
used for power, connect
to a dc voltage source
according to configuration
•
as an option we can
supply a fourth lead that
can be used for linear
intensity control. See
datasheet for graph of
voltage vs power output.
WhIte lead
Black lead
red lead
GreeN lead
clamping area = For optimal performance and lifetime of the laser, fixing the laser using a c-mount bracket (or any
bracket with increased contact area) is recommended. the designated clamping area of the laser can be found on the
mechanical drawing in the datasheet.
refer to electronics table in troubleshooting section for operating voltages for your specific laser configuration.
