OSEE LCM156-E, User Manual

Page: 11 / 85

Unpack and Installation
5
Chapter 2 Unpack and Installation
Unpack:
When unpacking the LCM156-E monitor, please verify that none of the components
listed in Table 3.1 are damaged or missing. If there are any components missing,
please contact your distributors or OSEE for it.
Table 3-1 Packing List
No. Item Quantity
1 Device 1
2 Pedestal with screws 1
3 Power cord 1
4 Adapter 1
5 User manual 1
Installation:
1.
Prepare for installation
Please follow the procedures below before installing LCM156-E:

Check the package and equipment for any visible damage that may have
occurred during transit.

Confirm all the items listed on the packing list have been received.

Remove all the packing material including electrostatic-resistant packing.

Retain these packing materials for future use.
2.
Install the LCM156-E in your desired method. Adequate ventilation is
required when installed to prevent possible damage to the LCM156-E.
(Note operational specifications are 40
0
C (100
0
F)).
There are screw holes at the rear panel of LCM-E series monitors, which are
labeled in the following figures. Insert the pedestal into the case, and fasten it with
the screws provided. The pedestal of LCM156-E(Optional), LCM170-E and
LCM230-E are not quite the same. The pedestal installation for LCM215-E and
LCM240-E are quite the same as LCM170-
E’s. Assemble the pedestal as follows.