HMV160 High-definition Multi-viewer Display Processor User Manual
-8 -
1.
Open the front panel.
2.
Press the swivel handle of the main board.
3.
First make sure that the frame stands firmly, and then gently pull the module along the slot out
of frame.
4.
Install the front panel.
5.
Loosen the screws of back connector, and remove
the back connector.
6.
Install the Blind Flange.
Notes:
1.
When the power is turned on, do not remove the front panel too long. If the user must remove
the front panel for a long time, please make disconnect the power supply.
2.
Do not block any ventilation openings.
3.
If the user needs to remove the back connector, please install the Blind Flange.
If there is no Blind Flange, please do not remove back connector.
4.
Please do not remove the back connector when the power is turned on.
2.8 Remove the Power Supply Module
There are two power supply modules in the HMV160. Please refer to the following methods to
remove the power supply module.
a)
Cut off the power supply.
b)
Disconnect the power cord, and remove the screw under the power connector.
c)
Make sure that the frame stands firmly, and then gently pull the power supply module along
the slot out of frame.
