OSEE HCM-700, User Manual, Page: 26 / 75

Monitor Settings
20
2.
Enable an output interface
After setting the input source, it will be output to the two output interfaces: SDI
OUTPUT and HDMI OUTPUT . Whether you can get the signal source from the
SDI OUTPUT
interface or the
HDMI OUTPUT
interface, it is determined by the
subitem setting of input output

OUTPUT .

Enable SDI output interface: set input output

OUTPUT

SDI as ON , as
shown in Figure 4.2-3, then you can get a signal source from the SDI
OUTPUT interface.

Disable SDI output interface:
set
input output

OUTPUT

SDI
as
OFF
,
then there will be no signal output from the SDI OUTPUT interface.
The setting for HDMI
output interface is as the same as the SDI’s above, no
further description.
Figure 4.2-3 Enable SDI Output
For example : if the signal source is set as HDMI , enable the SDI output and
disable the HDMI output, then, you can only get the HDMI image from the SDI
OUTPUT
,
but can’t get anything from the
HDMI OUTPUT
.
4.2.2
Controls
The CONTROLS menu items are used to adjust volume, backlight, rotating image,
and set anamorphic ratio and image size from DSLR device. The menu items are as
shown in Figure 4.2-4:
Figure 4.2-4 Controls Menu
Table 4.2-2 Description of Controls Menu Items