The arming/disarming command is accompanied by four short beeps of the siren and a blink-
ing indicator (see section 4.1).
When the communication loss with the receiver, the keypad continues to search it. Therefore,
when you turn off the receiver or control panel for a long time, it is recommended to remove the
keypad’s battery.
4.1. LED Indication
The keypad has a built-in multi-color indicator on the front panel. The execution of the com-
mand is accompanied by the current security status indication with a four-time indicator flashing:
armed – in
red
; disarmed – in
green
.
This indicator provides the display of the following keyboard operating modes:
Binding
– blinking green while waiting for a signal from the Lun-R receiver to register in
the control panel memory;
Bound
– when the binding is completed successfully – turning on red for 2…3 seconds;
Battery low
– a single flash in
red
when any key is pressed;
Battery normal
– a single flash in
green
when any key is pressed.
4.2. Group Arming/Disarming
The keypad controls the security mode of the group where it is assigned to by the 4-digit
codes. The control codes must be set in the control panel configuration previously.
To
arm
the group into
normal security mode
, enter a digital code and a key, for example:
To
arm
the group into
stay home mode
, press a key then enter a digital code and a key,
for example:
To
disarm
the group enter a digital code and a key, for example:
The key is used to reset the already entered digital code until the key is pressed.
The execution of the command is accompanied by an indication of the current security state
(see section 4.1).
4.3. Binding
A new keypad must be bound to the control panel in order to successfully transmit its com-
mands to the receiver.
To register a keypad, do the following:
1. In the control panel configuration, pre-set the required number of radiozones, their type,
group membership and other parameters;
2. Turn on the control panel in the operating mode and switch to the desired control
panel’s group;
3. Switch the control panel to the wireless keypads binding mode (see the corresponding
control panel programming manual);
4. Install the battery to the keypad observing polarity;
5. Switch the keypad to the binding mode by short-circuit the
RESET
contacts for 2…3 sec-
onds (until the blinking green – the signal "
Binding
");
6. Binding will processed automatically and, if successful, ends by turning on the red LED
for 2…3 seconds (signal "
Bound
").
The keypad waits 70 seconds for binding. To reinitialize the binding process, briefly close the
RESET
contacts again.
Keypad-R
Version en_2
5
