3. Mounting instructions
12
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastraße 11 • 73119 Zell unter Aichelberg • Germany
Tel.: +49 (0) 7164 797 01-0 • Fax.: +49 (0) 7164 797 01-51 • e-mail: [email protected] • www.ortlieb.net
3.2 Removal of the end-stop
-
Remove the clamping head
-
Release the bolts (3x120°) through the
borings of the base body
-
Remove the end-stop to the front through the
chuck
-
Insert clamping head (4)
* Only on End-Stop or Dead-Length chucks
Important:
If the chuck is supplied with a sealing between clamping head and end-stop, the sealing must be
removed first before removing the end-stop!
3.3 Installation of the protective sleeve
After removing oft the end-stop the provided
protective sleeve must be installed.
- Remove End-stop (2) (see
chapter 3.2)
- Insert protective sleeve (1)
- Tighten locking screws 3x (3) with Allen key
(4) and use low force
