OPERATION
Fireplaces
MODEL
OFP-36LED | OFP-42LED | OFP-50LED | OFP-60LED | OFP-72LED
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Charcoal Fire Colour
Touch the button to turn charcoal fire ON. There are 10 colours in total. Press this button to change colour.
The display will show C1, C2......C0 (all colours on loop) to change the different charcoal fire to be the same as the flame colour.
Heat Setting
This fireplace consists of a fan forced electric heater with two heat settings: 650W ("LO" shown in display) and 1300W ("HI" shown in display).
Touch the button once (the icon will light up) to activate the heater at its low level (650W). Touch the button once more to activate the heater at its
high level (1300W). When set on a high level, touch the button once again to deactivate the heater.
* The fan will continue to run for a short time and turn off automatically after the heater is turned OFF.
Timer
Set the timer using the button (1 to 9 hours), press button once for 1 hour increments.
Select the temperature display mode of Celcius (C) or Farenheit (F), simply press and hold button for 10 seconds to change.
•
The F temperature range display shows from 86°F, 84°F, 82°F......to 62°F
•
The C temperature range display shows from 30°C, 29°C, 28°C......to 17°C
REMOTE CONTROL FEATURES
1. Install the CR2025 3V battery in the remote control
2. Turn the master switch ON the electrical fireplace to 'I' so that it can receive
the signal from the remote control
3. Lock the colour for the flame using button 1. Lock the colour for the Log
using button 2. Press the button to see and choose the colour
4. CAUTION — NEVER leave the electrical fireplace unattended while heating
TEMPERATURE LIMITING CONTROL
This
heater
is equipped with a Temperature Limiting Control.
Should the
heater
reach an unsafe temperature (+115°C), the
heater
will automatically turn OFF.
To reset, unplug unit from wall, wait for 5 minutes. Then, plug back in and continue using the
heater
.
CLEANING
Turn heater OFF and unplug from outlet. Use a vacuum or duster to keep heat and vent area clean from dust and dirt.
The exterior should be cleaned with a damp cloth or duster.
DO NOT use abrasive cleaners, liquid sprays, or any other cleaner that may scratch the surface.
WARNING
Turn OFF the fireplace completely and
let it cool before servicing.
