INSTALLATION GUIDE
Micro Compact Series
MODEL
OD
M-5004 | ODM-8010
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Assembly Instructions
4. Mount to I-joist
a) Slide one hanger bar into channel on the housing
and adjust as needed
b) Hold housing in place so that the housing contacts the
bottom of the joist
c) Screw housing to joist through the hole of the housing
d) Screw the hanger bar onto the joist through the hole
e) Screw hanger bar to housing with screw
a)
Slide one hanger bar into the channel on the housing
and adjust as needed to fit between framing
b)
Hold housing in place so that the housing contact the
bottom of the joist. Screw housing to joist through
the
hole of the housing
c)
Screw the hanger bar onto the other side of joist
through the hole
d)
Screw hanger bar to housing with screw
e)
Refer to the diagram on the right
3. Mount with Mounting Holes and Hanger Bar
6. Install Duct and Blower Assembly
a) Install duct from the inside of the housing.
Fix the duct by the tab
b) Fix the BLOWER ASSEMBLY to the housing by 3 screws
5
.
Mo
unt with Additional Mounting Holes
The interior of the fan housing contains additional
mounting holes in case exterior mounting is not
possible
.
Screw or nail the fan housing directly to the
framing
or joists.
Remove the blower assembly as
directed in the service parts section on the very last
page of this instruction manual to gain access to the
additional mounting holes.
