background image

WARNING

LED 

Slim Lights

MODEL

 

DISC-RG2

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

 

Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or

 

use of this product, consult a competent electrician.

INSTALLATION GUIDE 

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY

A QUALIFIED

 

ELECTRICIAN. 

1.

LED 

Slim Lights

 

are suitable for

 indoor use only

. DO NOT use outdoors

2.

Please keep the LED

 

Slim Lights

 

a

way 

from any corrosive substance

, and please use dry

 

cloth 

when you clean them

3.

LED 

Slim Light

s

 can only be installed by a qualified electrician

4.

Before installation or maintenance, please disconnect the power 

to prevent electric shock

Instruction Manual

1-888-543-6473
1-888-541-6474

13376 Comber Way 

Surrey BC V3W 5V9

[email protected] 
www.ortechindustries.com

375 Admiral Blvd

 

Missis

s

auga

ON L5T 2N1

CAUTION

Tools Required

Application Notice

For your safety, this fixture MUST be wired in accordance to electrical codes and ordinances 

Saw

Measuring Tape

Electrical Wiring (use type and gauge suitable for

application to connect the fixtures)

Pre-installation

1.Turn power OFF from the electrical panel before starting installation
2.Locate a suitable position to plate the fixture and open in 

accordance to the cut-hole dimensions (refer to HOLE CUT SIZE 

TABLE below for appropriate size)

3.Run electrical wire from the switch (power supply) through the 

mounting hole — use NMD90 Romex or BX cable 

Driver Wiring

1.Open the hardwire box swing cover and remove the appropriate knockout(s)
2.Insert the electrical supply cable through the knockout and secure with a 

cable connector (sold separately) 

3.Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box. 

Connect WHITE wire of cable to WHITE wire of box. Connect BLACK wire of 

cable to BLACK wire of box (see Fig.1 on the right)

4.Place all wiring and connections back into the box and close the cover
5.Insert hardwire box through the mounting hole (see Fig.2 on the right).

New Construction Applications:

   

Hardwire box shall be firmly secured after the mounting plates, studs, joists, 

or structural units have been concealed.

Remodel Applications:

   

DO NOT require the hardwire box to be firmly secured after the mounting 

plates, studs, joists, or structural units have been concealed.

Fig.1

Fig.2

White

wire

From

power

Hardwire Box

Green
wire 

(ground)

To

fixture

Black wire

Reviews: