ORTEC radEAGLE, User Manual

Page: 43 / 147

radEAGLE User Manual radEAGLE Advanced Menu
Current Dose Rate
Duration (Real, Live, Dead)
Maximum Peak Height
Current Count Rate
Vertical Scaling
Acquisition Status
Channel or Energy Axis
Count Axis
Figure 34: The spectrum screen
If you start recording data, the current spectrum is not cleared. To record a
pristine spectrum, use
Clear (see below) before Start .
Clear
Clear the current spectrum.
Analyze
Let the radEAGLE apply its identification algorithm to the current spectrum. The re-
sult is superimposed on the screen for a few seconds (Fig. 35 , p. 43 ).
Results (Confidence (1–10)
and Nuclide)
Identified Peaks
Figure 35: Result of a spectrum analysis
Cursor Right
Move a cursor into the spectrum diagram from lower to higher energies along the
horizontal axis.
The cursor is a vertical line (Fig. 36 , p. 44 ) labeled with the energy, the channel number,
and the number of counts at this position in the spectrum.
If you move the cursor beyond the left or right end of the spectrum, it wraps
around to the opposite end.
© innoRIID GmbH • 2019-04-11 Software 3.2.12 • Document 3.3.0o 43/147